vtyjhgbnlikgfudrtyfghnlk,gjvctrfghfgbhn
clark forklift gl35
type of transmission fluid a 1994 nissian forklift uses
80 weight transmission fluid is recommended for the Toyota forklift. The transmission fluid is actually hydraulic fluid. The transmission fluid should be changed every 250 hours.
To check the transmission fluid on a forklift, first ensure the forklift is on a level surface and the engine is off. Locate the transmission dipstick, usually found near the transmission assembly, and remove it. Wipe it clean, reinsert it fully, and then remove it again to check the fluid level; it should be within the designated range on the dipstick. If low, add the appropriate transmission fluid as specified in the forklift's manual.
The type of transmission fluid used in Clark forklifts typically depends on the specific model. However, many Clark forklifts use automatic transmission fluid (ATF), often specified as Dexron or Mercon. It's important to consult the operator's manual for your specific model to ensure you use the correct fluid type and avoid any potential damage. Always check the manufacturer's recommendations for the most accurate information.
Dextron 2 8.1Liters - Automatic
AW-32
Dipstick on the front, low to the ground, between the front wheels. Raise the mast and you will see it. The same fluid lubricates the front axle. Mine takes 15 quarts.
80W90
cause its broke
You may have a broken transmission or be low on transmission fluid.
Dextron 2