Hi! Try google, on briskoda forum there is an answer for that! simply seal the door using roof and gutter sealant, even better http://www.youtube.com/watch?v=7Km9Hi6P1bU
Check the Skoda windshield for leaks. Also check the firewall where ant wires or hoses come through for any possible leaks.
skoda
Check the seal around the door. If the seal gets flattened (from old age and use) it will allow water into the car. Had this problem with my 92 Sunbird. Replace the seal and it should solve your problem.
If you want to install door weatherstriiping on 2002 Volvo S80 you should try to follow this steps: Open the car door and inspect the existing door seal. Begin at one end and pinch the seal with your fingers and pull up. Find the anchor points for the old door seal and determine if it is glued or clipped or if screw fasteners hold it to the door frame. Use a razor to cut the seal away from the frame for glued applications, unscrew the fasteners for screw anchors or pull up on the seal with pliers where it clips into existing drilled holes in the door frame. Clean the door frame where the old door seal was attached. Clips that hold the new seal should be sanded lightly with Emery cloth. Door seals that use push clips should have holes that are clear of debris. Use a drill and bit to clean these holes. Clean the door frame down to the metal where the old door seal was laid if the old seal was glued to the frame. Stretch the new door seal around the door frame for a proper measurement. If the new door seal has push pins or slides that need to be mated with the holes or slides on the car door frame, then you must adjust the position of the new seal to match the anchor points on the frame. For glue-type door seals, you just need to cut and measure to the correct length. Secure the new car door seal to the car door frame. If you are screwing the new seal in place, use the existing anchor points to fasten the door seal to the door. For a seal using fasteners, push the new fasteners into the existing holes. Glued seals will require you to spread an even layer of glued along the outside of the door frame and then center the seal and press firmly to affix the door seal to the frame. Glue should be allowed to dry at least six hours before closing the door, preferably 24.
If the new door seal has more clips than is necessary to install it on a Jeep Wrangler, the seal can be trimmed with a scissors to fit the door. Another way to remedy this is to return the door strip to the store where purchased and get the smaller, half door seal.
the door seal has a magnet strip in it
Defective windshield seal? Defective door seal or door not adjusted properly?
Defective windshield seal? Door not aligned properly? Defective door seal?
I got that problem too but I found out if you're doing the second quest with the brothers you have to kill the Banche then the door will open, hope this helps
The seal around your back door is not working properly. This is allowing the rain to seep in through the seal and run down the inside of the door.
To create an airtight seal.