The best way is to pressure was the entire underside of the vechical to get all the slat & sand off before you work on it. No need to have all the rust and salt falling into your eyes as you work.
Spray averything down with Fluid Film to loosen any rust or corrosion, let it sit for a few days.
then jack up the truck, block the axcels for it does not fall and crush you while you work.
Buy the brand new set of brake pads from me that I dont need because I sold my GMC/Chevys and just install them.
Raybestos BruteStop Series BD369M Front Disc Brake Pad Set Just $40
Capt@WickedGoodOutdoors.com
Read more: How_do_you_change_front_brake_pads_on_a_1999_GMC_Suburban
a torx bit size t-55 for front brakes
No special tools needed.
ratchet or socket
more infoAre you talking about front or back? The front pads are easy to change. The rear may require a little more work and some special tools. what kind of special tools
with tools.
Running light bulb replacement is simple on the Chevy Tahoe. I just did it today on my 2000. Follow the easy and well written instructions in the vehicle manual under "bulb replacement". No tools necessary.
It is not the proper tools that are needed it is the expertise and knowledge. If you do not know what you are doing, take it to a professional.
You Don'tThis is a job for a professional with the tools and knowledge necessary for this repair. Not a job for a novice. ^^^^^^^^this is not the best answer that someone gaveits not that complicated takes basic skillsemail me and i will give you step by step instruction
The tools needed for an oil change tend to be common tools. A floor jack is needed to access the oil pan. A pan which is used to drain oil into. A wrench and socket set is used to remove and replace the oil cap.
I HAVE A PUMP 4 U ITS FROM A 2005 SILVERADO WHAT TYPE OF ENG DO U HAVE ..................
All you need is common hand tools. A boxed end wrench and sockets.
brake fluid.10 mm 11 mm , wd40, and a buddy to help ya