Flare nut
Why is thread sealing co Pound not used on flare connections
no because a solar flare cant actually hit the earth the earths magnetosphere protects it there for the flare will not hurt you physically
A flare joint is used on gas fittings and uses a nut and flare fitting to make the connection. This is a dry fit with no joint compound. The copper is soft enough that it compresses with the nut and forms the seal.
When you use soft copper tubing, you flare the end to make the connection. You put a nut on the tube and then flare the end so that it looks like a funnel. Then you can connect the tube to a fitting and when you tighten the nut it compresses the copper and makes a seal.
It is common for a Fibromyalgia flare up to follow a stress event like surgery. It is important to take care prior to surgery and do all that you can to minimize the stress and reduce risk of and duration of any potential flare-ups.
There are o-ring seals at every line connection.
O-ring or flare is only the type of seal it has where it connects to the evaporator and the liquid line. The valve and the way it works is the same on either types of connection.
Human are the smartest creatures on the entire universe. When you compare the seals to the human beings, they are actually dumb.
Despite what you may have heard, harp seals do not actually play the harp. They bark, like other seals.
taking this can actually cause a flare up before your levels are under control
Flare fittings are useful when the connection would require removal at times such as piping an ice maker for a refrigerator. They are used with soft copper tubing that usually comes in rolls. Below are some steps to accomplish this: 1. Cut pipe to length. 2. Insert nut onto tube. 2. Clamp flare fitting tool onto tube. Make sure that it is flush with the clamping bars. Turn screw until it bottoms out into tube. 3. Remove tool and install connection. http://www.infobasearticles.com
AP Flare = Atmospheric Pressure Flare