Courtesy of "Skidsmadawg96"
Click here for details on how to get the codes if the following instructions don't work!
(1) Cycle the ignition key On - Off - On - Off - On within 5 seconds.
(2) The Odometer will show the P-code.
(3) If no DTC's are present, the cluster will display one of two texts: "P1684" and "done" or only "done." P1684 indicates that the memory has been cleared within the last 50 ignition cycles and does not indicate a problem. Done indicates that NO DTCs are present.
Ho2S = heated oxyen sensor, TP = throttle position, MAF = mass airflow, MAP = manifold absolute pressure, TC=turbocharger.
Some codes might not be used by Chrysler, or might only be used by some later Chrysler models (e.g. Charger). These will be italicized.
where is the thermostat located on the dodge intrepid 2004
disconnect battery for 30 seconds
The transmission dipstick runs along the driver side of the engine.
Valve clatter? Check oil level and pressure? Fuel mixture?
Reading the codes requires a scan tool.
The 3.5 litre V6 engine in a 2004 Dodge Intrepid has a timing BELT
With an OBD2 scan tool.
go to autozone to ask to check your codes
Auto Zone will check your engine codes for FREE. After finding out what cause your engine light to come on. Then the problem can be resolve with out guessing.
Front left of engine.
The codes are read with an OBD2 scanner.
In a 2004 Dodge Intrepid : The 2.7 litre V6 engine has a timing CHAIN ( also , the 3.5 litre V6 engine has a timing BELT )