A resistor is used to represent any one of many different components, called loads, that convert electrical energy to other forms of energy. For example, motors, toasters, lamps, radios, televisions, microwave ovens, and electric kettles convert electrical energy to motion, heat, sound, and light.
Low resistance is easy to push electrons through,
High is hard.
Low resistance: Copper wirehigh resistance : rubber band
All loads are conductive, otherwise no load current would flow. A resistive load is one that has no inductance or capacitance.
nothing
When using a resistive load bank to test a generator, it does not matter if you load the generator to its kW or kVA rating, because those two numbers are the same when considering a resistive load. Power factor, which is the difference between true and apparent power, only comes into play when there is a reactive (inductive or capacitative) load.
The phase angle is defined as the angle by which the load current leads or lags the supply voltage.For a purely-resistive load, the phase angle is zero, because the load current is in phase with the supply voltage.For a purely-inductive load, the phase angle is 90 degrees lagging.But few loads are either purely-resistive or purely-inductive; typically, most loads are resistive-inductive. This means that, typically, the phase angle lies somewhere between zero and 90 degrees.
No, a geyser is a resistive load.
A purely resistive load is one in which there is no capacitive or inductive reactance. Whe driven by an AC voltage source, such a load will have no shift in phase angle between voltage and current.
No load is the least destructive load to a switch.
when a resistive load is applied there is no phase angle difference between voltage and current. when a inductive load is applied there is phase difference between voltage and current. current lags voltage by an angle of 90 degrees for pure inductive load
When using a resistive load bank to test a generator, it does not matter if you load the generator to its kW or kVA rating, because those two numbers are the same when considering a resistive load. Power factor, which is the difference between true and apparent power, only comes into play when there is a reactive (inductive or capacitative) load.
It is resistive much load
The phase angle is defined as the angle by which the load current leads or lags the supply voltage.For a purely-resistive load, the phase angle is zero, because the load current is in phase with the supply voltage.For a purely-inductive load, the phase angle is 90 degrees lagging.But few loads are either purely-resistive or purely-inductive; typically, most loads are resistive-inductive. This means that, typically, the phase angle lies somewhere between zero and 90 degrees.
resistive loadAnswerIf the current is driving a motor, then the load is resistive-inductive.
The PF will increase
Voltage and current will be in phase for a purely resistive load. As a load becomes more inductive or capacitive, the phase angle between voltage and current will increase.
No, a geyser is a resistive load.
Amps is a measure of current flowing in a circuit. Volt-Amps or (VA) is a measure of power and is equivalent to wattage for a pure resistive load.
the filament is made of tunguston which is having high resistance value,Hence it's resistive load
A purely resistive load is one in which there is no capacitive or inductive reactance. Whe driven by an AC voltage source, such a load will have no shift in phase angle between voltage and current.
specification of inductive load,capactive load,resistive load in laboratory