It is resistive much load
Some examples of resistive loads are: heaters, incandescent lights, fans etc.
when a resistive load is applied there is no phase angle difference between voltage and current. when a inductive load is applied there is phase difference between voltage and current. current lags voltage by an angle of 90 degrees for pure inductive load
A wattmeter (not 'watt-meter') will always measure the true power of a load, regardles of whether that load is purely resistive or not. This is because a wattmeter effectively measures the in-phase component of the load current.
When it supplies a resistive load.
Voltage and current will be in phase for a purely resistive load. As a load becomes more inductive or capacitive, the phase angle between voltage and current will increase.
resistive loadAnswerIf the current is driving a motor, then the load is resistive-inductive.
The PF will increase
No, a geyser is a resistive load.
the filament is made of tunguston which is having high resistance value,Hence it's resistive load
specification of inductive load,capactive load,resistive load in laboratory
No load is the least destructive load to a switch.
Some examples of resistive loads are: heaters, incandescent lights, fans etc.
When using a resistive load bank to test a generator, it does not matter if you load the generator to its kW or kVA rating, because those two numbers are the same when considering a resistive load. Power factor, which is the difference between true and apparent power, only comes into play when there is a reactive (inductive or capacitative) load.
the ampere i=0is theonlyedge where the e0b and e0c can come together and share the load and that way the two vector diagrams will connected and the load will be less resistive and more on the ek0 and c73 resistive load. the 38f93 relay will be the one to break the load 2u3 and e0b and e0c into diffrent components that will be drawn in the diagram.
The maximum load for resistive devices is 1800W, while for tungsten devices it is 600W. This means that devices with resistive load can safely draw up to 1800W of power, while devices with a tungsten load should not exceed 600W to prevent damage to the equipment and ensure safety.
With a pure resistive load the Power Factor should be 1.
resistive load. I assume that the stove you are reffering is with heating coils.