i got a Chevy k 5 put a 350 in it every thing works but it wont get any spark it is a carb motor in a fuel injection wiring harness
The wiring harness for the radio in a 1991 GMC Pickup is going to be behind the radio. The wiring harness is plugged into the back of the radio. The fuse for the radio is in the fuse box located on the driver's side below the dashboard.
www.installdr.comthey have wiring harness diagrams for all makes
WIRING DIAGRAMS TOYOTA WIRING DIAGRAMS TOYOTA
Go to autozone.com. They have wiring harness diagrams for free download for most vehicles. If found all wiring diagrams for my 88 Silverado.
You can reset the 1997 Ford F1 50 pickup truck computer by removing the wiring harness from the computer. Keep the wiring harness disconnected for 30 seconds and then plug it back in.
Buy the repairing book of Haynes.. it has everything in..
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
I know for the 6 wire wiring harness that goes to the voltage regulator white=Battery, red=ignition, yellow=charge, but Im not sure what green, blue, or the white one that has a black strip. Im also trying to figure out what these mean.
Sure.. just pull the wiring harness to run the EFI. the carb motor harness wont run the efi.. yes it will. i did it in my truck
it's located under the intake manifold. the knock sensor is most likely ok' the porblem is the short wiring harness from sensor to main wire harness.
The purpose of the wiring harness is to help keep wires together instead of hanging freely. You can purchase a new wiring harness at any auto repair shop.