There are no symptoms. The knock sensor is a passive part that does not do anything if it's not activated. Knock sensors codes on the Villager/Quest are usually caused by some other component, not the sensor itself.
you will have a knock sensor code and the car will run slugish. when a knock sesor code is set its retards the timing so the engine will not detonate. the easyiest way to fix it is relocating the sensor.
There are no symptoms since the knock sensor doesn't do anything unless the engine is detonating, in which case it would do nothing and you would hear it. The knock sensor code is often tripped when there is a fault in something else since it's part of the same circuit. This is considered a "ghost" error code.
LS does not have a knock sensor. GSR does have a knock sensor
The knock sensor detects spark knock or ping.
Where is the knock sensor for a 99 pathfinder
that the knock sensor does
knock sensor location
you mean knock sensor
I don't believe it has a knock sensor.
Knock sensor = CKP sensor on this vehicle.
The knock sensor retards the engine timing when there is a knock or ping detected. This will make the car a little sluggish. It is rare that the knock sensor goes bad.
A knock sensor tells the engine computer when one or more of your engine's cylinders are "knocking", that is, exploding the air/fuel mixture in a way that delivers less power and can be damaging to the engine if prolonged. The computer uses this information to tune the engine so that it doesn't knock. If your knock sensor wasn't operating properly, so that it was always indicating a knock, the engine computer's response may have been to change the ignition timing on your engine. The knock sensor generally threads into the engine block. This code may show up intermittently or the Service engine light may be lit constantly. You may notice drivability problems including a lack of power and perhaps some hesitation. There may also be other symptoms. * The knock sensor is faulty and needs to be replaced * There is a wiring short/fault in the knock sensor circuit * Check the resistance of the knock sensor (compare it to factory specs) * Check for broken/frayed wires leading to the sensor * Replace the knock sensor