0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are the 2 types of brake systems?
Air and hydraulic brake systems.
Difference between pneumatic and hydraulic machine?
Pneumatic system is operated by compressed air while hydraulic system is operated with pressurised hydraulic oil or any type viscous oil. Hydraulic systems can usually produce higher control forces and work under extreme operating conditions. This is the system that is primarily used on aircraft to move control surfaces and engine controls. You can often classify pneumatic systems because they have a pump (gas pump) and hydraulic systems have a piston. That is the difference. Also, pneumatic systems are louder because it is a gas under pressure. 1. By definition, hydraulics is used in controlling or harnessing power with the use of pressurized fluids whereas pneumatics studies how pressurized gases influences mechanical motion or movement. 2. Hydraulics uses an incompressible fluid medium like oil whereas pneumatics uses a compressible gas like air. 3. Hydraulic applications demand greater pressures during operations that reach thousands of pounds per square inch whereas pneumatic applications only require 100 psi pressures more or less. 4. Most hydraulic applications generally use bigger components that pneumatic applications. 5. Hydraulic systems are generally more difficult to operate compared to pneumatic applications
When i depress my brakes only the passenger side front brakes work the drivers side is not even getting power why is this?
It sounds like you may have a problem in the hydraulic system or the caliper. Hydraulic systems are routed 2 ways for brakes, either front and rear, or a diagonal split. To see if it's in the system, apply the brakes and see if only the one wheel is affected. If not, look at the proportioning valve or master cylinder. If it is, try opening the bleed screw on the affected caliper and have a helper lightly press on the brakes. You should see a steady stream of fluid with no bubbles in it. If not, the rubber line is probably damaged. If you do, the caliper itself may be seized. For any brake problem, make 100% sure you are comfortable doing the work. You don't what a failure while driving. If not, seek competent professional help. I have related links attached to my bio here at Wiki.
What are some cordless 2-line phone systems?
There are many 2-line cordless phone systems. AT&T and Panasonic sell these phone systems at retail stores such as Walmart. Walmart sells many of these systems in their stores.
How do you replace rear brakes on a 1999 Mazda millenia s?
I am not a mechanic but, this was an easy fix. There are 4 bolts that you'll remove, 2 that hold the caliper and 2 that hold the hydraulic system. Loosen all 4 bolts and remove. The caliper will be released and you simply remove 2 spring clips and remove the old pads. Use a C clamp to comnpress the brake hydraulic piston. Then reverse the the removal procedure and there you are. It's a very simple deal. Of all the brakes I've replaced this was fairlly painless.
What are 2 advantages of a hydraulic system?
Pneumatic systems use air or a gas which is compressible. When compressed, water can form in pneumatics.Hydraulic systems use oil or a transmission fluid, which is comparatively uncompressible, meaning more efficient power transmission and higher operating pressures.
Functions which valves perform in a hydraulic circuit?
Various valves are used. 1 - hydraulic flow. 2 - adjustable hydraulic pressure. 3 - control of hydraulic flow.
How do you put brakes on a boat?
1. Put it in reverse at low speeds 2. Attach hydraulic trim tabs with plenty of travel for high speed braking 3. Invent something else that will conveniently induce drag
What could cause a 65 VW hydraulic reservoir to lose so much fluid every few days when none of the wheel cylinders show signs of leakage?
Probably from the reservoir it self or the lines going 2 the Master Cylinder or the Master Cylinder it self.Park the car on a tarp or many newspapers & that will show U where the leak is.could even B a brake line GOING 2 the rear brakes.
Is there a return fuel line on a 1975 Chevrolet truck with a 2 barrel carburetor 350?
No, there is no return line. Because of the low pressure of fuel systems on carberated vehicles, there is no need for a return line.
Why is it hard to stop in your 2001 Lincoln LS?
1. You need new brakes. 2. The brakes you have are cheap. 3. You may have dirty or old brake fluid. 4. Possible air in the brake line. 5. Weather conditions could be a factor.
How do you remove the hydraulic line from the transmission?
in the clutch kit u get a easy disconnecter tool that u slip in between the plastic slip guard and the metal piece and pry up don't cut the line hard as hell 2 find
