oxygen...25psi acetylene....7-10psi. Never go higher than 15psi with acetelyne. it will become highly volitile
The Oxy-acetylene flame is much hotter and the preferred combination for the welder especially when welding pipe and plate metal. Somewhat of a rare welding procedure in modern times. Replaced by arc welding. Liquid Propane Gas burns cooler and is preferred by employers as it is cheaper. Not bad results on light gauge material, again takes longer to heat up. -RedSeal Welder
Oxy-acetylene (notice the spelling) came first.
Evan A. Atkins has written: 'Electric arc and oxy-acetylene welding' -- subject(s): Electric welding, Oxyacetylene welding and cutting, Welding
Acetylene welding is a process in which like metals are joined by heating them to their melting temperature with an oxy-acetylene flame produced by a torch.
LPG is liquid petroleum gas and oxy-acetylene is oxy fuel welding. The LPG can be used as an alternative to oxy-acetylene and is cheaper and can be purchased in bulk. The oxy-acetylene is best used when making shorter, thinner, and faster cuttings.
I was taught oxy/acetylene welding first, then stick. TIG welding is just like oxy/acetylene except much easier (less variables and a foot control to make minor corrections or even pulse the weld) I would recommend you learn both. TIG welding for precise/clean welding. Stick for some larger, perhaps special welding (hard facing tools - bigger pieces of steel).
To my knowledge there is no process called Argon Welding. Argon is an inert gas used to protect the weld puddle when using the GTAW (TIG/Heliarc) and GMAW (MIG) process. Almost all welding processes utilize electricity. OAW (Oxy-Acetylene now called Oxy-Fuel) being the exception.
Types are aluminium, steel, bronze, brass, etc...
Arc and oxy acetylene welding were both discovered around 1900. Plus or minus 5 years or so, but it's kind of fuzzy...
It is called aluminum welding. Aluminum can be TIG welded, the most common method, or oxy-fuel welded, or stick welded, or MIG welded.
It is called aluminum welding. Aluminum can be TIG welded, the most common method, or oxy-fuel welded, or stick welded, or MIG welded.
S W. Miller has written: 'Oxy-acetylene welding'