Want this question answered?
You can try to get a bigger carburetor for the bike. The XR80 carburetor will fit with some modifications. Another possibility is to bore the engine out to 90 cc but then you will need a different piston and rings.
Float may be stuck in carburetor, or you may need to turn the petcock to the off position when not riding (if applicable). ~RC@HD~ ANSWER: Another posibility is that the gas cap is not venting correctly and when the bike sits in the sun, presure builds up in the tank forcing gas out of the overflow vent in the carb.
I need the information where to connect the Hydrogen Gas to the carburetor on what side
You spelled it correctly, but in case you need it again: Overflow In a sentence: I overflowed my bathtub. Hope this helps! :)
No.
if the float/needle assembly do not seat properly. the gas will slowly leak past the needle and into the cylinder-then past the rings into the oil. you probably need a carburetor rebuild.
You did not need to know the amount of water originally in the overflow container because it could be easily calculated with the existing information.
In which countries srilankan passport holder does not need visa?
They do not NEED rings. The Earth, for example, is a perfectly well formed planet and it manages to do that without rings!
The carburetor is normally found just above the engine, it controls the petrol and air mix prior to combustion. Fuel injected and diesel engines do not need a carburetor.
This is typically caused by a stuck or faulty float valve in the carburetor. Usually a good carburetor cleaning will take care of it. At the worst you will need to replace the carburetor.
form_title= Nissan Carburetor form_header= Replace your Nissan carburetor with help from experts. When was the last time your oil was changed?*= _ [50] Do you need a new or used carburetor?*= () New () Used Have you noticed any problems with your Nissan?*= () Yes () No