0
What are the addvantages of using a loopback interface on a router with ospf enabled?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you delete a loopback interface on a Cisco router?
(config)#no interface loopback x
What are two advantages of using loopback interface on a router with oSPF enabled?
loop back never goes down, helps maintaining adjacency of routers if used with routing protocols
What is an advantage of using a loop back interface on a router with OSPF enabled?
The main advantage of running a loop back interface with OSPF enabled on the router is that there is minimal cost. The IP address will also remain stable in this set up.
What are devices connected to host called?
Configure the router ID on both routers. Configure the R2 router interfaces for area 0. Configure a loopback interface on both routers. Configure the proper subnet masks on the router interfaces.
Does a Local Area network uses a router?
The highest MAC address among the active interfaces of the network will be used. There will be no router ID until a loopback interface is configured. The highest IP address among the active FastEthernet interfaces that are running OSPF will be used. The highest IP address among the active interfaces will be used.
What is the router interface that connects to a LAN called?
Outbound interface
Router have a mac id on its interface yes or no?
it should be on back of router!
Which command enables rip on a router?
A(config)# router rip A(config-router)# passive-interface S0/0 B(config)# router rip B(config-router)# network 192.168.25.48 B(config-router)# network 192.168.25.64 A(config)# router rip A(config-router)# no network 192.168.25.32 B(config)# router rip B(config-router)# passive-interface S0/0 A(config)# no router rip
What is true about the router ID in a single area OSPF network?
The router ID is used to uniquely identify each router in the OSPF routing domain.If no loopback interfaces are configured, the router chooses the highest active IP address of any of its physical interfaces.
When a router does not have an interface for the destination network it sends the traffic to where?
If a router has a route in its routing table, it will have a next hop IP address and / or outbound interface. If a router does not have a route in its routing table the packet will be dropped.
What kind of physical interface does the router have?
AUI
Which prompt is used to allow a user to change the ip address of an interface on a router?
Router(config-if)#
