0
Which prompt is used to allow a user to change the ip address of an interface on a router?
Wiki User
∙ 13y ago
Router(config-if)#
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
A network technician wants to configure an IP address on a router interface by using the ip address 192.168.1.0 255.255.255.0 command Which prompt should the technician see when entering this comman?
router(config-if)#
Starting at the enable mode prompt what commands would you type to configure IP address 192.168.1.1 on interface E0?
I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#
What is global router configuration?
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
Which command turns on a router interface?
While in the interface mode your prompt should look like this:RouterName(config-if)#Then type the command:RouterName(config-if)# no shutdown
Which fields of the IPv4 header change from router to router and why they change?
IP address remains the same. Mac address changes from router to router.
When a router does not have an interface for the destination network it sends the traffic to where?
If a router has a route in its routing table, it will have a next hop IP address and / or outbound interface. If a router does not have a route in its routing table the packet will be dropped.
To which network device or interface does the IP address 192.168.1.254 belong?
That is normally the IP address of a router
What is the effect of issuing the hostname RouterA command on a router?
A description will be configured on the router interfaces identifying them as belonging to RouterA.The router will attempt to establish a connection to the host with the name RouterA.The router will map an IP address to the domain name RouterA.The router prompt will change from Router(config)# to RouterA(config)#
What mode must be in to configure IP address on a Cisco router?
interface mode
What address should be pinged from this host to confirm that the router interface is operational?
Default Gateway
What is the purpose of FastEthernet interface?
Connects the router to a single broadcast address. e.g. LAN
What is the minimum configuration for a router interface that is participating in IPv6 routing?
link-local address
