0
While in the interface mode your prompt should look like this:RouterName(config-if)#
Then type the command:
RouterName(config-if)# no shutdown
Wiki User
∙ 8y ago
Wiki User
∙ 10y agono shutdown
Add your answer:
Earn +20 pts
When must a router serial interface be configured with the clock rate command?
When the interface is functioning as a DCE device
What command line interface command can be used to check the routing table of a router?
Showi ip route
What is the result of using the clock rate 56000 command at the serial interface of the router?
The interface is configured as a DCE device.
What is the command line interface used for on a cisco router?
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
What is the command line interface used for a Cisco router?
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
What does it mean when a user sees the command prompt Router config-if?
On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#
What is the effect of configuring the IPv6 unicast-routing command on a router?
By configuring an IPv6 Unicast routing command on a router you are allowing the router to communicate with the IPv6 interface. This is needed if you intend to send or receive data over an IPv6 network.
What are displayed by the Router show cdp neighbors command Choose three?
Platform Holdtime Local Interface
What command could be issued to determine if the router has experienced any input or output errors?
show interface
What additional command mustbe issued by the technician to activate the interface to forward traffic?
Router(config-if)# no shutdown
What command is used to stop rip routing updates from exiting out an interface but still allow the interface to receive rip route updates?
Router(config-if)#no routing
Where is router configuration?
Configuring a physical router requires software like PUTTY. while configuring router on Software like packet tracer is done on CLI (i.e. command line interface).
