0
What else can I help you with?
What command do you use to check errors on juniper router?
show interfaces <interface name> extensive Also, #show log messages to see general system errors rather than just interface specific errors.
What command determines the router data to get particular destination?
The command used to determine the router data for a specific destination is typically the "traceroute" command (or "tracert" on Windows systems). This command traces the path packets take from the source to the destination, revealing each hop along the way and helping to identify routing issues. Additionally, the "ping" command can be used to check the reachability of a destination and measure round-trip time.
How can you check to see if a fastEthernet interface on a router is connected to the fastEthernet interface on another network device?
Check the network card and the properties are listed there.
How can you check to see if the fastethernet interface on a router is connected to the fastethernet on another networking device?
Smell the router to see if it's in heat.
What command verifies the existence of a node on a network?
PING command verifies the existence of a node on a network. Ping command is a command of command line interface . It is used to check if the host is alive or not.
What command would you use to see if clocking is stopped on an interface?
To check if clocking is stopped on an interface, you can use the command show interfaces [interface_name] on Cisco devices. Look for the "clocking" status in the output; if it indicates "Clocking is stopped," then the interface's clocking is indeed halted. This command provides detailed information about the interface's operational status, including any issues related to clocking.
Ford Taurus heater routing diagram?
If you are looking for a diagram of your heater router, check the owners manual. If there is not one pictured you can contact the manufacturer.
What command would the network administrator issue to determine if load balancing is in effect on a router?
To see whether load balancing is in effect, check the routing table. Load balancing is in effect if two or more routes are associated with the same destination.The show ip route command reveals that the destination network 192.168.6.0 is available through 192.168.2.1 (Serial 0/0/0) and 192.168.4.1 (Serial 0/0/1).
How do you find the gateway address under router based network?
To find the gateway address in a router-based network, you can check the network settings on your device. On Windows, open Command Prompt and type ipconfig, then look for the "Default Gateway" under your active network connection. On macOS or Linux, open a terminal and type ip route or netstat -rn, and the gateway will be listed as the default route. Alternatively, you can log into the router's web interface using its IP address, typically 192.168.1.1 or 192.168.0.1, and find the gateway information there.
Why does Logic Pro not hear audio while recording?
Logic Pro may not hear audio while recording due to incorrect input settings, issues with the audio interface, or problems with the audio routing within the software. It is important to check the input settings, ensure the correct audio interface is selected, and verify that the audio routing is properly configured in order to resolve this issue.
2 How do routers use the routing table to determine the best path to a destination network?
They check the number of hops a packet passes to reach the the destination. The router then uses the route with least number of Hops.
Hi ive got a wireles msi router and is working if i connect through a cable but if i try through wireless it says connected but then the internet cannot be dispayed. what and how do i change d setting?
If you have everything, change for newer firmware.If you did not try much yet, try reseting the router (there is bottom on the router) to manufacture settings. Check properties for wireless connection, make sure that your MAC is allowed to have access to internet, check routing tables if you have it. Some router allow to limit access for some particular networks (LAN, WLAN).
