0
What else can I help you with?
What command do you use to check errors on juniper router?
show interfaces <interface name> extensive Also, #show log messages to see general system errors rather than just interface specific errors.
How can you check to see if a fastEthernet interface on a router is connected to the fastEthernet interface on another network device?
Check the network card and the properties are listed there.
How can you check to see if the fastethernet interface on a router is connected to the fastethernet on another networking device?
Smell the router to see if it's in heat.
What command verifies the existence of a node on a network?
PING command verifies the existence of a node on a network. Ping command is a command of command line interface . It is used to check if the host is alive or not.
Ford Taurus heater routing diagram?
If you are looking for a diagram of your heater router, check the owners manual. If there is not one pictured you can contact the manufacturer.
What command would the network administrator issue to determine if load balancing is in effect on a router?
To see whether load balancing is in effect, check the routing table. Load balancing is in effect if two or more routes are associated with the same destination.The show ip route command reveals that the destination network 192.168.6.0 is available through 192.168.2.1 (Serial 0/0/0) and 192.168.4.1 (Serial 0/0/1).
Why does Logic Pro not hear audio while recording?
Logic Pro may not hear audio while recording due to incorrect input settings, issues with the audio interface, or problems with the audio routing within the software. It is important to check the input settings, ensure the correct audio interface is selected, and verify that the audio routing is properly configured in order to resolve this issue.
2 How do routers use the routing table to determine the best path to a destination network?
They check the number of hops a packet passes to reach the the destination. The router then uses the route with least number of Hops.
Hi ive got a wireles msi router and is working if i connect through a cable but if i try through wireless it says connected but then the internet cannot be dispayed. what and how do i change d setting?
If you have everything, change for newer firmware.If you did not try much yet, try reseting the router (there is bottom on the router) to manufacture settings. Check properties for wireless connection, make sure that your MAC is allowed to have access to internet, check routing tables if you have it. Some router allow to limit access for some particular networks (LAN, WLAN).
How can you check to see if the fast Ethernet interface on a router is connected to a fast Ethernet interface on another networking device?
Just properties of the network card. The speed of connection is there. Knowing the speed and capabilities of the network card you are looking at, you can find out which interface is used at another end. PS: The speed you will see is the highest both devices can support in the same time.
How do you test a Ethernet port?
to check if your Ethernet card r INTERNET is working r not, just type the following in command prompt: ping 127.0.0.1 This command is basically used for self test of NIC(Network Interface card) card
How can I check a bank routing number?
You can check a bank routing number by looking at the bottom left corner of your checks or by contacting your bank directly.
