Connects the router to a single broadcast address. e.g. LAN
Check the network card and the properties are listed there.
Smell the router to see if it's in heat.
On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#On a Cisco router, that means that you entered interface configuration mode; any command you give will affect the selected interface. For example, you may have given the commands:Router>enableRouter#configure terminalRouter(config)#interface FastEthernet 1/0Router(config-if)#
UBAMA(config)# interface FastEthernet 0/1Use this UBAMA(config)# interface FastEthernet 0/1 to correcty configure the connection.I Hope this could help. And also online pc repair if your having problems in yourComputer, Fast and reliable accurate service from the exact moment you need id
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
That the duplex configuration may be mismatched
fastethernet
issue the no shutdown command on interface FastEthernet 0/1
The TCP/IP information is supplied to any DHCP client on the network connected to the FastEthernet 0/0 interface of R1
FastEthernet Port Serial Port
The IBM General Purpose Interface Bus (GPIB) Adapter connects IBM Personal Computer (PC) products to a general-purpose interface bus.
It stands for "General Purpose Serial Interface", it is used as an interface between Ethernet MAC and PHY blocks.