The FastEthernet interface of R1 is disabled.
One of the default routes is configured incorrectly.
A routing protocol is not configured on both routers.
The default gateway has not been configured on both routers.
series and parallel are different types of circuits that a robot can contain
Almost any PC can be used for programming almost any PLC system The programming interface will be either a serial port, a USB port of increasingly, an Ethernet port. The PC will usually require the appropriate development software that is supplied, in most cases, byt eh PLC manufacturer.
It's used to connect to a serial device to a computer. The term "serial board" usually refers to an electronic printed circuit board that can be plugged into a computer, in order to attach an external device via a serial interface. In the past, the most common type of serial interface was RS-232, this was used to connect all kinds of devices to computers, most notably modems. These days, RS-232 has been replaced by USB, which stands for Universal Serial Bus.
this is connector chip used for asynchronous serial interface and its task is to make voltage level operative for next connected device.it is usually used in pc and microcontroller interface
Serial Processing means that the processing that occr sequentially.Results of one action are known before a next action is considered.In the case of batch processing execution of a series of programs or jobs on a computer without mannual intervention.
It stands for "General Purpose Serial Interface", it is used as an interface between Ethernet MAC and PHY blocks.
Gigabit Ethernet interface Controller interface Serial interface Multilink Group interface MFR (Multilink Frame Relay bundle interface) Dialer interface Loopback interface Tunnel interface ATM interface
Serial printers are connected via the serial (COM) port of the computer. "Non-serial" printers are connected through another interface, such as the parallel port, USB, ADB. FireWire, etc...
A serial bus.
Ethernet is the Technology which is Best Situated to LAN , Ethernet has all Features which LAN Need Like High Bandwidth cost Of Deployement,and Coverage Where as Serial Technology, is Best Situated for MAN and WAN , they received data in packet and transmit to long distance they have Control Signal Also who Safe data from error and Corrupt In Ethernet data are not check Bit Wise(LAck of Control Signal) In Serial Technology data are check Bit Wise
Ethernet hardware addresses are 48 bits, expressed as 12 hexadecimal digits (0-9, plus A-F, capitalized). These 12 hex digits consist of the first/left 6 digits (which should match the vendor of the Ethernet interface) and the last/right 6 digits which specify the interface serial number for that interface vendor. These high-order 3 octets (6 hex digits) are also known as the Organizationally Unique Identifier or OUI. A list of ethernet vendors are at : <URL:http://www.cavebear.com/CaveBear/Ethernet/vendor.html> <URL:ftp://ftp.cavebear.com/pub/Ethernet-codes> <URL:gopher://ftp.cavebear.com/00/pub/Ethernet-codes>
What do you need to interface to? I have projects with 20+ connected in serial RS485 Modbus to a PLC or 20+ connected to an Ethernet bridge to view them via a touch screen display What would you like to know?
give the difference between serial port and parallel port
Status of "down" means no pc is connected where as "administratively down" depends upon the clock pulse of the interface.
Status of "down" means no pc is connected where as "administratively down" depends upon the clock pulse of the interface.
No, bluetooth is a serial interface.
I am assuming you mean what is SCSI used for? In this case, SCSI does NOT mean "small computer serial interface," instead, it means "Small Computer SYSTEM Interface." SCSI is used as a fast interface between a host adapter and the CPU that can daisy chain as many as 7 or 15 devices on a single bus.