There are a number of factors that would affect the answer to this question including torque, shaft speeds, load etc. This is why there are many methods of delivering force to remote locations (worm, belt, chain). I believe some of the advantages when working with belts are - reduced friction losses as the belt has more contact area - decreased energy loss through vibration (in effect a belt has vibration dampening) - belt breakage usually seperates the drive system causing little damge or danger unlike chain If someone can answer the physics side of this I would be most appreciative as most of these answers come from car knowlege (see variable belt drive vs. timing chain).
Sleep and creep does not take place for the v-belt.
compare to flat belt it will be very less.
slip ratio is more for flat belt compare to flat belt
Belt drives can be used when the distance between two shafts(for transmitting power) is large and are relatively cheaper than gear drives.
Ans by Krishna Raj Salim :
Advantage: A belt drive posses lesser weight than the chain drive.
Disadvantage: Slip
trgthyujugty
A flat roof is a maintenance nightmare year after year. So many people have made that mistake only to later put a pitched roof over the flat roof to avoid any more hassle.
because of high output drive,easy to manufacture and takes less space and also low power consumption...
You're probably getting a little water on the belt. Check to see if there is a dust cover, mud guard or whatever it's called for your vehicle. Someone may have removed it over the years and now when you splash water it causes the belt to slip.
The Advantages are that Hovercraft can fly, or more suitably, hover over water and land, can go over rough terrain and does not pollute as much as cars.
less expensive
Sleep and creep does not take place for the v-belt. compare to flat belt it will be very less.
Advantages of chains over flat belt drive Smoother operation Quieter running No mess left on the rear wheel, like a chain leaves Very low maintance it last longer than belts.
Adjusted too loose, belt is glazed over and worn out, replace it.
easy to upgrade
No. Porsche uses 2 timing chains that drive their over head cams in their flat six boxer engines used in their 911 and Cayman/ Boxster engine family.
there is none.....drive a stick shift
103,000, and I was advised not to drive over that until the timing belt was replaced
Yes. Drive belts are what keep the engine parts working together in order. If the drive belt goes, the engine will crank with the key turned, but the engine will not "turn over."
Overloading your Kenmore front load washing machine can cause increased wear on the Belt drive. Over time, the belt may wear out and break.
a SATA hard drive can be connected to and controlled by a SAS hard drive controller
Makes no difference what your gender is. The advantages are the same. You can get from one place to another faster if you can drive. It gives you a sense of freedom and control over your own dstiny. Just have fun and be careful.
Belt drives can be used when the distance between two shafts(for transmitting power) is large and are relatively cheaper than gear drives.