The spark plug for a Stihl FS36 is a Bosch WSR6F gapped at .025
turn in then 1 1/4 turns out on high and low factory settings hope this helps
Per the tech manual, clockwise until it stops, then back 1 1/4 turns.
there is no RPM settings for a chain saw, it is controlled by the gas trigger, when cutting wood run it full throttle, the rpm settings for stihl varies depending on the model of the unit. all stihl products have an idle rpm setting and wot rpm setting
Factory carb settings for a 84 Honda 200s
The answer is that it is an 1118 120 0601 by the Stihl parts catalog, but if you know a good Walbro dealer it is a WA-128-1 at 2/3 the price.
Check out the related link below for information.
High is 7/8 ths of a turn out from lightly seated. Low would be 1-1/4 turn out. This is ball park settings. The saw should run but will need fine tuning. Be careful not to turn the H screw in to far and lean out the mixture and damage the motor. http://store.chainsawr.com/
If it's an 066 go 1 turn out from seat for high and low. No 064 to my knowledge.
I cant kept it running
47-52 depending on carb settings
it is albanian it means lives