The cylinder head torque specs are;
stage 1: 30 Nm-
stage 2: 50 Nm-
stage 3:105 Nm
Start the engine, allow to run for 20 mins then switch it of and allow to cool for at least two &half hours. slacken each bolt of (IN TURN) and re tighten to:
a torque setting of 105Nm.
The sequence is a little harder to set out... there are 17 head bolts all in. Looking at the engine (front). Left side there are 4 bolts. Middle there are 5 bolts. On the right side there are 8 bolts. number from front to back:
left side. 12,4,5,13...
Middle. 16,8,1,9,17...
Right side.15,11,7,3,2,6,10,14...
Tightening sequence should start with No1: then 2 & 3 and so on, in a ever widening circular motion. to prevent head twist... DO NOT FORGET TO REPLACE THE HOLE SET OF HEAD BOLTS... It is a nightmare to get broken ones out.
What is the Cylinder Torque sequence 2000 Pontiac Montana 3.4V6
what is the head torque sequence for a 1991 pathfinder
Yes
21ft lbs
the correct torque for cylinder head bolt of kia pregio 2.7 diesel is 130-135ft-lbs.
in sequence torque bolts to 20nm, then again in sequence turn a futher 120 degrees, and again in sequence 120 degrees.
The cylinder head torque settings are a list of parts in the torque sequence. It tells where everything is and can be found.
100ft lbs
headboltstork
petrol/deisel 2.4 or 3.0??
65 flbs
What is the torque specs on a 585 case ln tractor head gasket