0
The circuit is callaed lumped circuit whose elements can seprate(eg rectifier circuit in pcb). but in the distributed circuit we can seprate the elements from the circuit(eg transmision lines)
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the difference between lumped element and distributed element resonators?
The difference is that in a lumped element resonator, the circuit's elements are localized together. In a distributed element resonator, they are spread apart.
Is transmissionline lumped element or distributed element?
transmissionline is a distributed element
What is the difference between lumped and distributed network?
Lumped systems are those systems in which electrical properties like R, L, C etc are assumed to be located on a small space of the circuit. these systems are applicable for low frequency application. On the other hand Distributed systems assume that electrical properties R, L, C etc are distributed across the entire circuit. these systems are applicable to for high (microwave) frequency application. Unlike the lumped element model, it assumes non-uniform current along each branch and non-uniform voltage along each node.
What is difference between lumped and distributed elements?
simply defining Lumped elements are components available in market i.e., resistors,capacitors,inductors...... Whereas Distributed elements are inbuilt property( resistance,capacitance,inductance )of a connecting wire
What has the author M Ronald Wohlers written?
M. Ronald Wohlers has written: 'Lumped and distributed passive networks' -- subject(s): Passive Electric networks
What has the author P K Majithia written?
P. K. Majithia has written: 'Functional adjustment of thick film distributed lumped active low pass filters'
What is the systemic circuit?
In the systemic circuit, oxygenated blood is distributed to body tissues.The systemic circuit also distributes nutrients to the body tissues and removes waste.
How the section of a transmission line can be used as lumped circuit element?
Actually in networks we will consider the elements like resistance, inductance, capacitance as lumped elements for simplicity, like this in power systems we will consider the transmission line parameters(resistance, inductance, capacitance) as lumped elements, because we will calculate all the parameters of power systems with respect to receiving end or sending end but not with respect to middle of the line. If a fault occurs on transmission line then we should not consider the lumped elements of that total transmission line, we should consider the lumped elements from sending end to the point where the fault is occurred.
How is current distributed in a series circuit?
In a series circuit, all components gets the same amount of current passing through them.
Does a fire alarm circuit have to be in a separate conduit?
yes because of it having a signals, if it mix with power cable, fire alarm circuit get distributed.
How GHz range system clock frequency is generated If so Is it possible with transistor circuits or lumped circuit?
It's generated using a quartz crystal and frequency multipliers on a motherboard.
What is mean by lumped element in electronics?
lumped" means that the dimension of you ckt element is much smaller than the wavelength of the signal passing through it. Therefore, you can treat your ckt element as a lumped unit (against the wavelength), and do not have to worry about wave propagation phenomenon "within" your ckt element. The opposite of "lumped element" is "distributed network." Typically, in low-frequency ckt/network, since the frequency is low, therefore, the wavelength is large (wavelength = propagation speed(usu. speed of light) / frequency ), so most elements can be treated as lumped. However, as frequency goes higher and higher, the wavelength becomes shorted and shorter, the wave propagation effect WITHIN the ckt element becomes more and more pronounced.
