Want this question answered?
Burette is used to measure the accurate value of taking products and we will calculate the lower minuscus and upper minucus of the burrete that's why we using the burette
A burette is preferred for titration over a measured cylinder because it can give a finer volume reading. You can also add in all your chemicals at the start of the experiment.
the burette is more accurate than the pipette as it contains marks like a ruler so you are able to clearly identify the volume. However, with a pipette you can only measure the volume nearest to the ml.
A titration is the use of carefully measured amounts of a known solution to determine the concentration of another. They often involve acid-base neutralisation or oxidation-reduction reactions (examples would be sodium hydroxide with hydrochloric acid, or permanganate with an iron solution). The main part of the system is the burette, a large graded tube with a controllable variable nozzle at its end. This nozzle is used to add different amounts with great precision to the solution being tested, so that an exact reading can be made - if done correctly, the titration's accuracy is limited only by the scale on the burette. A sample of the test solution (collected using a pipette with a known volume and high degree of accuracy; the sample is called an aliquot) is placed in a container, usually a conical flask, under the burette. The burette is filled with known solution, i.e. one where the concentration is know to another high degree of accuracy. The two are mixed slowly and allowed to react - for acid-base titrations an indicator will be added to the flask, for redox the solution which will change colour is put in the burette. This is continued slowly until the solution will barely react with that from the burette. At this point the amount of solution taken from the burette is recorded. Ideally, the next slightest drop of burette solution will cause a change in colour of the solution that does not change at all. If not, the new recording is made and the last step repeated. This amount is a titre. The whole experiment is repeated several times. The data is collected and averaged out. From this, an amount of known solution used, an amount of tested solutio used and eventually a concentration can be found.
Check for damage, volume (is it the correct volume for your procedure? is it a blow out pipette? where the meniscus should fall before proceeding), clean and dry, use index finger to control volume, always condition equipment.
using pycnometry because the density of water is very accurate
First remove all the solid particles from the burette using a scrubber. Then wash the burette with tap water followed by distilled water thoroughly (even the nozzle). Then wash the burette with the solution to be used in the burette.
Burette is used to measure the accurate value of taking products and we will calculate the lower minuscus and upper minucus of the burrete that's why we using the burette
The likely incidents and accidents that are likely to happen are some of the factors that need to be considered when using training to implement an organization's health and safety policy.
The likely incidents and accidents that are likely to happen are some of the factors that need to be considered when using training to implement an organization's health and safety policy.
Using the term bias is not considered slander in itself. This would depend on a lot of other factors surrounding the incident.
u must consider the suppliers, the existing technology and the users u should also have the mission for such ideas of using electronic systems
u must consider the suppliers, the existing technology and the users u should also have the mission for such ideas of using electronic systems
Wen u start using technology for stuff like farming
absorption, route of administration, and site of infection
age time on the job pay if it is salary or commission and if the person has invested in the company.
A burette is preferred for titration over a measured cylinder because it can give a finer volume reading. You can also add in all your chemicals at the start of the experiment.