Don't bother with torque specs, rust and worn bolts can make the torque innacurate. Just make nicely tight with one hand on wrench (DO NOT STRIP, A 12-POINT BOXED END WRENCH IS GOOD ENOUGH). You can also put anti-seize on bolts (only a little)... you never know if you will be the next person that has to remove them.
the main caps are 75 pounds of torque. but i dont know the rod breaing specs.
There are more than 50 torque specifications for your 1984 Honda 200. A complete list of torque specifications can be obtained from most Honda dealerships.
The 1984 258 cubic inch engine rocker arm bolt torque specification is 30 pounds. You should torque the rocker arm bolts in 15 pound intervals.
tighten the bolts to 46 ft lbs working from the center out and then go back over them and tighten them an additional 1/4 turn
Weight of a 1984 holiday rambler
Seek around the flywheel, The Flywheel is between engine and transmission. The starter is probably under the intake like the 7MGE.
The diesel engine available in the 1984 Ford F-250 is a : ( 6.9 liter / 420 cubic inch / V8 diesel )
No
if it is diesel a duramax diesel if its gas it will be a duramax
22re rod bolt torque
1984
The only 350 available in a 1984 El Camino was the diesel. If your V8 isn't a diesel, it's a 305.