Carefully tighten the bolts in a crisscross pattern to 45 inch pounds. Then re-tighten them to 83 inch pounds.
by hand :)
There is 2 of them and they are underneath the intake manifold. You will have to remove the intake to get to them.
No it is not . It won't even begin to bolt up. It's all different.
There is 2 of them and they are underneath the intake manifold. You will have to remove the intake manifold to replace them are even see them.
On a 5.3. at the top rear of the engine, behind the intake manifold. I is very difficult to get to without first removing the intake manifold.
That engine has 2 of them and there underneith the intake manifold. You will have to remove the intake to get to them.
Under the intake manifold, sucks but enjoy!
Thay are not inside the intake. They are UNDERNEITH the INTAKE. It has 2 sensors and you can not see are get to them until you remove the intake.
The labor charge to replace and intake manifold gasket, on a 1999 Chevrolet Tahoe, is approximately $180. It takes approximately 2 1/2 hours to replace the gasket.
It will be on the left side of the intake manifold, under the map senor. Towards the back
There are two knock sensors located in the block. They are just under the intake manifold.
depends on the year model I know that my 2001 has 2 and they are located under the intake manifold.