A theodolite is a tripod mounted level used to measure horizontal and vertical distances and a measuring tape is a tape marked with increments: usually feet and inches (but also other increments such as tenths)
Ferhan ahamed
Error message displayed when an internal problem presits. You have to turn off and then back ON total station just before starting to operate...If the problem was not fixed this way you have to send your instrument for repair.
Bulk density is the dry mass of the solids (M sub t) / total volume (V sub t) Particle density is bulk density (P sub b) / 1 minus total porosity (1-theta).
Sorry i am still an amateur. The function of a total station in a construction site have various use. Some of the most common are COGO, mapping & stake-out. But the first and foremost of total station is to measure angle & distance, which can then be calculated coordinates (XYZ or NEZ)
Hire Some Surveying Company and do it with Total Station which will give you the accuracy of 1 mm/ 0°00'10"
What is the difference between theodolite and total station?
What is the difference between theodolite and total station?
lkjeokwokeo3o3o3
The main difference is the method of measuring distances. Tacheometry is optical. A total station uses electromagnetic waves. Distances measured using Tacheometry are determined by multiplying the difference in readings to a levelling staff between the upper and lower stadia hairs, by a constant (usually 100). A Total station, by definition, is a theodolite with a built-in EDM measuring device. This sends out a signal of a known wavelength to a reflector and calculates the distance by measuring the time it takes for the signal to return.
*find a theodolite or total station *check for collimation *check theodolite vertical axis *set up the theodolite a distance away from the foot of the tower, or closer but using a diagonal eye piece *use left face to bisect bottom point and clamp the horizontal plate *check the tower zenith transit and use the right face to bisect the bottom point and do as explained above *dont forget to record readings of every stage.
What is the meaning of total Station?
Basic measurements in surveying include distance, elevation, and angles. Distance is typically measured using instruments like a tape measure or electronic distance meters. Elevation can be determined using a level or GPS equipment, while angles are usually measured with a theodolite or total station.
The distance between New York Penn Station and New York Union Square is walkable. The total distance on foot is 1.65 miles
which institute gives training in total station in new dehli
This is a bad question.
Males typically have a higher TRC than females.
there are many total station machine with different specification. now gps, robotic total station available they work with one person. easy way to survey of land.