Fill valve, Douglas valve , Over flow tube, handle , stopper , flapper , float, lift rod , guide rod tank bolts, disc
water. h2o. two parts hydrogen and one part oxygen
the tank has 333 parts
i am sharing same problem with you, my wc water tank cracked.
Go to any auto parts store and ask for fuel additive for your poblem.
The water will be at the bottom of the gas tank, typically near where the outlet to the engine is; so disconnect the outlet hose at this point, and allow water to drain until gas is coming from the hose. Then get some "gas dryer" at the parts store, and add an appropriate amount to the tank to mop up the water under this outlet.
They weaken the little plastic parts inside the tank so they break. I learned this when I had to replace the insides of my tank. The chemical in the water corrodes the plastic.
To clean a Culligan water system tank, first disconnect power to the unit. Remove the salt tank cover and carefully lift the brine valve out. Scoop out and discard the brine and salt. Remove the screws on both side of the tank and lift out the brine valve chamber and the salt plate at the bottom of the tank. Scrub and clean the tank. Replace the removed parts. Refill the tank with clean salt almost all the way to the top of the tank. Fill the tank with 4 to 6-inches of clean water. Restore power to the unit and it is ready for use.
If water doesn't go into the pressure tank you will not have water pressure.
It is a used tank that has been fixed or had parts replaced.
in a tube that goes in to you and cumes out in to a tank
"SeaFoam" sells a product for that. Check with your local auto parts store.
The only way to know for sure if a person has water in the gas tank is to drain the tank. Usually a car will sputter and die if there is water in the tank.