0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What procedure of turbine commissioning?
the steam strikes/enters the turbine th turbine rotats at requried speed.then it connected to genaretor ,the electricity genareted
What do you mean by turbine synchronization?
During a typical power plant startup, all components of the power plant are started slowly. The turbine is first rolled at a slow rpm. Then the rpm is increased gradually to a point where it can match the frequency of the grid. At this point, the turbine can be synchronized with the grid and start outputting electricity into the grid.
What is warm rolling of steam turbine?
You don't start a large turbine cold. Typically, the lubrication system is started, the turning gear is engaged and warming steam (a small amount of steam, not enough to turn the turbine) is admitted to the turbine to warm and initially expand the shaft and casing. If this isn't done, thermal shock from the admission of high pressure superheated steam into the cold turbine could damage it.
What should eccentricity be on a steam turbine before startup?
eccentricity measurementof shaft at slow roll speed. WITH BEST RGARD AZIZ JAMALI SR SUPERVISOR INSTRUMENT FFBL KARACHI PAK AZIZ.JAMALI@YAHOO.COM +923462243209
What is difference between radial flow turbine and axial flow turbine?
in a radial flow turbine the steam enters the turbine in the direction of its radius and leaves it in the direction of the axis of the shaft. in a axial flow turbine the steam enters the turbine in the direction of the axis of the shaft and leaves the turbine in the same direction.
How many type of turbine cold startup?
water tube boiler
What is cold rolling of steam turbine?
When Turbine shaft temp is below 100 deg.centigrade,Then rolling of turbine carried out it is called cold rolling.
What procedure of turbine commissioning?
the steam strikes/enters the turbine th turbine rotats at requried speed.then it connected to genaretor ,the electricity genareted
What are the turbine generator start up rmp for a cold start?
It may be depends on the Constructor/ Design of Turbine .
What steps needs for start a steam turbine from cold conditon?
steam turbine cold start up list:
What do you mean by turbine synchronization?
During a typical power plant startup, all components of the power plant are started slowly. The turbine is first rolled at a slow rpm. Then the rpm is increased gradually to a point where it can match the frequency of the grid. At this point, the turbine can be synchronized with the grid and start outputting electricity into the grid.
What is cold rolling wider?
When turbine shaft temp is below 100 deg.centi, then rolling of turbine carried out it is called coldrolling wider.
Procedure of a small wooden wind turbine electrical energy from wind?
i dont know what it is either
What is warm rolling of steam turbine?
You don't start a large turbine cold. Typically, the lubrication system is started, the turning gear is engaged and warming steam (a small amount of steam, not enough to turn the turbine) is admitted to the turbine to warm and initially expand the shaft and casing. If this isn't done, thermal shock from the admission of high pressure superheated steam into the cold turbine could damage it.
Is it ok to have a colonoscopy with a head cold?
It is usually best to wait until you are well for any procedure. Inform the doctor who is scheduling your procedure of the cold and they can decide, based on your symptoms and the date of the procedure, if you should have the procedure rescheduled.
What is the cold cut procedure for pipe?
The cold cut procedure for cutting a pipe is the omission of gas lines. It is cutting without the hazards of sparks and flames.
What is the purpose of NV RAM on a Cisco router?
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
