today i observed errors between puppy dial reading & height gauge dial reading. this was 10μ to 20μ when we go to .1 mm
Standard height for urinal sensors should be 1450mm centre from floor level
what should be height of stack of 1250 kva D.G as per Indian pollution boardA: it should be 7.1 meter + building height of 1250kva Dg set installed.
It is the height, width and length of a jet engine.
By putting deaerator at height, vapour doesn't form at the suction area of feed water pumps so cavitation phenomenon in the impeller can be prevented. also to get NPSH.
by Projecting from a typical wall section -Alex:)
mechanical instruments like height gauge,verneir caliiper
You can use a measuring tape, a ruler, or a yardstick to measure your height.
It is pounds. An inch is the measuring unit for height. A pound is the measuring unit for weight. The logic is as follows. height, weight -> (measuring unit for height), (measuring unit for weight) Some similar examples, If it were "height, distance and inches." the missing word would be "miles" If it were "height, age and inches." the missing word would be "years"
It is pounds. An inch is the measuring unit for height. A pound is the measuring unit for weight. The logic is as follows. height, weight -> (measuring unit for height), (measuring unit for weight) Some similar examples, If it were "height, distance and inches." the missing word would be "miles" If it were "height, age and inches." the missing word would be "years"
Measuring length, width, height, and distance are all forms of what measurement?
Altitude. Height. Depends on what you are measuring.
This depends on what you are measuring. A tool that can be used is a tape measure.
What is the question?
· Engineer`s squares require no adjustment because they are fixed, however, they must be checked regularly for squareness· Vernier height gauges, vernier callipers, vernier protractors and combination squares slide back and forth to the requires height/width/depth/angle and then a thumb screw is used to lock them into position· Dividers are spring loaded, and can be set using a steel rule to ensure accuracy
You can measure the height of a person in meters.
Metres.
it is called a measureing tape