When turning left or right, you will hear a clicking noise.
If your car is not turning correctly, you will be able to tell either your CV axle or your control arm is bad. It will cost about $600 to fix either one, with parts.
A bad cv joint/axle shaft on the front will make a clicking noise when turning.
clicking when turning.
If it is a front wheel drive vehicle, it could be your cv axle or bad struts. yes bad shocks could cause vibration ,but i know my car had a bad cv axle in it a while back. the problem was the cv axle was broke in 2. Take it to an auto shop and ask them to test drive it and see if they can tell you what the problem might be. but if its a front wheel drive car, then i would bet money it is the cv axle but if its a rear wheel drive vehicle then ask them to check your universal joints(U-Joints.)
I think you mean axle shaft joint. The usual symptom of a bad axle shaft joint is a crunching noise when turning corners.
I am assuming the axle cv joint itself is bad an not just the boot. If the cv joint is bad you will have to replace the whole axle itself. 1. Drain transmission fluid. 2. Remove wheel. 3. Loosen and remove axle nut and remove whatever is necessary to free axle from wheel/suspension area. 4. Using a prybar or large screwdriver pop axle out of transmission and replace.
Usually you will here a popping sound when you are in a turn.
Bad inner CV joint?
No the axle shafts use CV joints.No the axle shafts use CV joints.
sound like a bad cv joint aka axle shaft check rubber boots on left and right axle if they are cracked and open chances are cv joint went bad from lack of luberication and contaminents
Sounds like a bad CV joint. On most cars, it is often more economical to replace the complete axle shaft on that side that has a bad cv joint. Hope this helps. Good-luck!
If you replace the entire cv joint axle in MD you will have $82 in the new axle + labor in a garage $40-$60 per hr. I did it myself. not a bad job.