I think you mean axle shaft joint. The usual symptom of a bad axle shaft joint is a crunching noise when turning corners.
Yes it does if the car is moving. Because the CV joint is part of the axil if the car is moving the bad CV joint will be moving too. or No it will not make noise if the car is in neutral and the car is not moving.
when you turn hard either way, it will make a loud clicking or popping noise
Bad CV joint.
clicking when turning.
Sounds like a bad CV joint. On most cars, it is often more economical to replace the complete axle shaft on that side that has a bad cv joint. Hope this helps. Good-luck!
If when turning you hear a clicking sound then it is likely a CV joint problem
I am trying to put CV joint into differential and i need to know how to make sure it is in.
The CV joint boot is bad, and needs to be replaced.
Could be a CV (constant velocity) joint going bad / gone bad. I would think the service folks would have noticed a split CV boot and tested for a bad CV joint, but you never know. A bad CV joint will produce a clicking / popping on a turn. It may be your tie rod ends. I had the same thing happen to my 1999 Passat and it was the outer tie rod ends. Probably is a cv joint. We just replaced one that went south at 23,000 miles. After you replace it, put the car out to pasture before it sucks you dry. These are common for bad a/c systems, motors and trannys.
CV (Constant-Velocity) joint
To determine if a CV joint is bad in a 2006 Trailblazer, listen for clicking or popping noises when making sharp turns, which often indicates wear in the joint. Additionally, inspect for grease leakage around the CV boot; a damaged or torn boot can lead to joint failure. You may also notice vibrations during acceleration, which can signal issues with the CV joint. If you observe any of these symptoms, it's advisable to have the joint inspected or replaced by a professional.
Bad CV joint.