0
You have to take the screws out and when he's bent over u screw the hole and that should fix the problem.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Why won't 1998 Chevy astro will not start has fuel and spark?
ignition module failure or ecm failure.
Symptoms of ignition coil failure?
There are 5 symptoms of ignition coil failure. They are: backfiring, starting problems, fuel economy is off (less millage per mile), engine misfiring, and vehicle stalling.
Where is the ignition module for a Pontiac Grand Am gt at?
Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products. Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products.
1994 olds achieva wont start when hot changed the ignition module work for a couple hours and now it wont stay on help?
The new ignition module may have failed. If it is a used module its probably happened. If its a new module it still sounds like failure.
Where is the ignition module located on a 1989 Mazda b2200?
where is the ignition module located on a 1988 Mazda b2200
Where is the ignition module 1999 Laredo?
The engine computer is the ignition module.
Where is the ignition module on a 1996 stratus?
The engine computer is the ignition module.
Where is the ignition module 97 explorer?
Where is the ignition module 97 explorer
What could cause an intermittent spark problem on your 86 iroc-z tpi car?
probably ignition control module failure
Does the ignition module cause misfire when hot on a ford f150?
did you changed your thermostat? You MUST keep around 195 degree thermostat in the vehicle at ALL TIMES due to the computer system. The ignition module usually gets hot due to corroded electrical connections at the ignition module and or the module is HEAT SENSITIVE and needs to be replaced. (plug wires) Ignition misfire can produce a variety of driveability symptoms including hard starting, rough idle, hesitation....
How do i change the ignition module in a 1998 suburban?
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Is the ignition control module going bad in your Honda Civic?
if you have been having intermittent power-accessory or dash light failure, and/or the car won't stay started (no idle), then yes, it can be your ignition switch module. when car won't idle, try turning and holding the key halfway between Start and On; if it then idles normally, it is definitely your ignition switch module. easy to replace.
