0
did you changed your thermostat? You MUST keep around 195 degree thermostat in the vehicle at ALL TIMES due to the computer system.
The ignition module usually gets hot due to corroded electrical connections at the ignition module and or the module is HEAT SENSITIVE and needs to be replaced. (plug wires)
Ignition misfire can produce a variety of driveability symptoms including hard starting, rough idle, hesitation....
Add your answer:
Earn +20 pts
Why does a 1993 Ford F150 4x4 pickup stall out after it heats up?
It sounds as if you have a bad ignition control module. It would be located on the distributor. On some of these vehicles, the module was moved over on to the side of the left fender. Ford had a lawsuit against them for these modules, but the time to submit claims against them has expired. It is also referred to as the thick film ignition (TFI)module.
Where is the ignition control module located on a 1992 ford F150?
Driver side inner fender, near the hood hinge. Grey or black with 6 wire connector. Mounts into an aluminum heat sink with two torx screws
How do you replace a F150 ignition switch without using the original keys to turn it up for the pin remuval?
Go to a dealer and buy a new key
How can I fix 2003 Ford F150 radio continues to play when engine turned off then wont start?
Sounds like it could be a bad ignition switch.
If you have a bad ignition coil on a 2000 F150 4x4 How can you identify the bad coil or coils that need to be replaced?
You will have to have it scanned for codes, check with your parts house. They may scan for you.
1995 ford f150 4.9 y Control Module - Ignition?
The ignition control module for a 1995 ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.
Where is the ignition module located on a 1987 Ford F150?
under the dist. cap
No spark on 1993 f150 what can it be?
Could be the ignition module. It's attached to the side of the distributor.
Where is the ignition control module located on a 95 ford f150 4x4 supercab 5.8 liter?
On the distributor
1993 f150 cranks no spark fuel pump starter coil ok?
Would be in the distributer or the ignition module
Where is the ignition module if it is not with the distributor in a 1992 Ford F150?
The only other thing you can really do is get a manual from your local parts store or online. The cost is about $20.
What is the hardest thing to diagnose in an F150?
Multiple & or random misfire(s)
What Causes a 96 ford f150 4.6 misfire?
In general (very loosely) a misfire can be a bad plug, wire or coil.
What would cause no electrical power to the ignition switch of a 1990 ford f150?
Ignition relay is probably shot. It is in the power distribution block in the motor comprtment.
What is Error code P0301 on a ford f150 2006?
misfire # 1 cylinder
Why does a 1993 Ford F150 4x4 pickup stall out after it heats up?
It sounds as if you have a bad ignition control module. It would be located on the distributor. On some of these vehicles, the module was moved over on to the side of the left fender. Ford had a lawsuit against them for these modules, but the time to submit claims against them has expired. It is also referred to as the thick film ignition (TFI)module.
What wires are positive on an ignition module for a 1982 F150?
Chances are there is no polarity. An ignition coil is simply a wound of wires used to generate high voltage. But you may find a marking on it such as a "+" or a red wire wich would indicate the positive electrode.
