answersLogoWhite

0


Best Answer

The ignition control module for a 1995 Ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1995 ford f150 4.9 y Control Module - Ignition?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the ignition control module located on a 95 ford f150 4x4 supercab 5.8 liter?

On the distributor


Where is the ignition module located on a 1987 Ford F150?

under the dist. cap


No spark on 1993 f150 what can it be?

Could be the ignition module. It's attached to the side of the distributor.


What is a pcm in a 97 f150?

Powertrain Control Module ( PCM )


Where can you find a replacement ignition key for a 1995 F150?

quiero saber si la troca F150 1995 tiene aigre a condisiado


Why does a 1993 Ford F150 4x4 pickup stall out after it heats up?

It sounds as if you have a bad ignition control module. It would be located on the distributor. On some of these vehicles, the module was moved over on to the side of the left fender. Ford had a lawsuit against them for these modules, but the time to submit claims against them has expired. It is also referred to as the thick film ignition (TFI)module.


1993 f150 cranks no spark fuel pump starter coil ok?

Would be in the distributer or the ignition module


What sensor regulates the air and gasoline Flow on a 1995 Ford f150?

The oxygen sensor in the exhaust ( 2 on a 1995 V8 engine ) is used to send a signal to the powertrain control module to adjust the air / fuel ratio


How do you change a ignition on a 1995 ford f150 with no keys?

Well you could ram a flat head into the ignition and turn it to the on position then take steps


What is a ford f150 pcm power control relay?

The power control module (PCM) is the brain of the vehicles engine functions. The relay is a module as part of its power supply circuit.


Does the ignition module cause misfire when hot on a ford f150?

did you changed your thermostat? You MUST keep around 195 degree thermostat in the vehicle at ALL TIMES due to the computer system. The ignition module usually gets hot due to corroded electrical connections at the ignition module and or the module is HEAT SENSITIVE and needs to be replaced. (plug wires) Ignition misfire can produce a variety of driveability symptoms including hard starting, rough idle, hesitation....


Where is the ignition module if it is not with the distributor in a 1992 Ford F150?

The only other thing you can really do is get a manual from your local parts store or online. The cost is about $20.