1.8 liter single cam engine: 4 to 6 degrees BTDC
1.8 liter dual cam engine: 9 to 11 degrees BTDC
10w30
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
No, it has motorized seat belts. The 1994 Protege is essentially the same car as the 1990 Protege, which is an economy car that cost about $10,000 new.
The horn for the 1990 Mazda Protege is located near the right turn signal at the front of the car. To the left of the radiator when your looking at the engine with the hood up.
5.7 quarts for automatic transmission
1.8 liter single cam engine (SE, DX): 4 to 6 degrees BTDC 1.8 liter dual cam engine (LX): 9 to 11 degrees BTDC
To set the timing on a 1990 Mazda E2000 van with an FE motor, first, ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Then, locate the timing marks on the crankshaft pulley and the timing cover; align them according to the manufacturer's specifications. Adjust the distributor position if needed, ensuring the rotor points to the correct ignition wire. Finally, double-check the timing with a timing light to confirm proper settings.
The HOLD light means you have an electrical problem with your transmission. See your mechanic ASAP.
I had the same issue with a 1990 Mazda 626 and replacing the timing belt cured it.
screwdriver, and then pull hard enough to rip out the wires and then there you have it. the way to remove a stock stereo the theft version
the lug pattern is 4x100 so cars like Mazda protege and Honda civic
This is an NHTSA-listed Safety Recall item. All Mazda USA dealers are to perform this Safety Recall work free of charge for all 1990-1994 Mazda Proteges and 1990-1994 Mazda 323s, but only if indicated by either a malfuntioning driver- or passenger-side passive shoulder belt.