answersLogoWhite

0

they are pop-up washers for your headlights.....have someone use windshield washer and observe them spraying a jet of water onto the headlights

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Does front bumper filler go top or bottom of bumper 1987 caprice?

Top


How does one remove a front bumper from a 1997 Jeep Grand Cherokee?

First remove the bumper cover. You need to take off the front grill to get at the plastic retainers that hold the top of the buimber on. There are about four retainers on the bootom of the bumper.


Suzuki top mileage?

how to change front bumper in 1996 Suzuki sidekick sport


Where is the radiator located on a 1992 astro van on the top of the engine or bottom?

the location of the radiator is in front of the engine.almost always in front behind the front bumper.


How do you remove a front bumper cover for an odyssey 1995?

1. Remove the two bolts underneath the ends of the front bumper with a socket wrench. 2. Unfasten the six clips underneath the front bumper along the center with a screwdriver. 3. Remove the two clips on the top of the front bumper next to the radiator, using a screwdriver. 4. Unfasten the screw that secures the front bumper to each fenderwell, using a screwdriver. The fenderwells are the void areas where the front tires sit in the vehicle frame. 5. Lift the front bumper off the frame of the Honda Odyssey and set it out of the way.


How do you take front bumper off an RSX?

To remove the front bumper remove the following: 12 plastic clips, 6 accessuble on the top, 6 accessible on the bottom 6 screws on the bottom. Bumper hangs on a series of hooks (6) just beneath the headlights.


How do you remove a bumper from a 1999 escort zx2?

To remove the front bumper on a zx2 , first you need to remove all of the fasteners on the top side of the bumper. ( open the hood and look straight down, remove all of those black plastic retaing screws.) After you remove the fasteners from the topyou need to lay down and get all of those small screws on the bottom/front of the bumper. Basically they just hold on the front splash guard but you need to remove them anyways. Once you take care of the top and bottom side of the bumper you need to remove both of the front inner fender wells. It's usually easier if you remove the wheels first. Once you remove the inner fender wells, get you a 3/8 drive ratchet wrench with a LONG extension. There are two (2) bolts on each side of the bumper, I believe they are a 13mm. Take out all four (4) bolts and then remove the front bumper cover and your done.


What is the top speed Chrysler prowler?

126-130 MPH. 2000 stock prowler. Front bumper removed.


Where is the alternator located on a 1996 Pontiac Bonneville SE?

It is located top left of the motor if you are looking at it from the front bumper


How do you remove front bumper on 306?

To remove the front bumper on a Peugeot 306, start by opening the hood and unscrewing the screws or bolts located at the top of the bumper. Then, remove any additional screws or clips located underneath the bumper and at the wheel arches. Carefully pull the bumper away from the car, ensuring to disconnect any wiring for fog lights or sensors if applicable. Finally, lift the bumper off the mounting brackets to complete the removal.


How to remove front bumper on a 2001 jeep wrangler?

There are four Torx head bolts that hold the bumper to the frame. Two on each side, one on top and one on the under side.


How do you top up power steering on a vectra c?

Its the transmition bottle behind the front bumper nearside just below the headlight. Stupid place to put it as you have to take the bumper off to get to it..