ttr 125 have about 73 horsepower stalk but the power to the h cap cilinders is terrible, it doesnt transfer the rog nig to the flex nard.
intruder lc 250 valve clarance spec place
For the Suzuki GS850G, the valve clearance spec is .03mm to .08mm for both intake and exhaust valves. Check here: http://members.dslextreme.com/users/bikecliff
.095 is the Honda spec i have the service manual
valve clearance should be pusted under tune up spec under "stock hood" sticker should be on the left hand side
0.004 - 0.006" with the last one being the published spec.
the manual say's that both valves are .13mm
what the torque spec for the cylinder head on a 2003 saturn L300
Spec Sanders died on 2003-07-06.
If you head to the AutoZone site and check the spec sheet, found here: http://www.autozone.com/az/cds/en_us/0900823d/80/17/ed/db/0900823d8017eddb/repairInfoPages.htm The 1990, model KA24E, the valve clearance is stated as NA, meaning "not adjustable" Hope that helps a little. If you head to the AutoZone site and check the spec sheet, found here: http://www.autozone.com/az/cds/en_us/0900823d/80/17/ed/db/0900823d8017eddb/repairInfoPages.htm The 1990, model KA24E, the valve clearance is stated as NA, meaning "not adjustable" Hope that helps a little.
Adjust valve clearance Intake COLD 0.21mm (0.008)in HOT 0.30mm (0.012)in Exhaust COLD 0.23mm (0.009)in HOT 0.30mm (0.012)in HOT = engine warmed up to normal operating temp. COLD = engine at ambient temp.
It is the "Advertised duration", used by the factory. It is the Valve timing from when the valve is .006inches off the valve seat to .006" off the valve seat.
go to the spare shop and ask for a spec sheet of your car . and it should be under the gap clearance section of the spec sheet