what are the vavle timing mark's for a 1994 Plymouth acclaim
If you have a 6 cylinder 3.0L the timing marks are located on the crankshaft gear for the timing belt (its just a notch on the rear of the gear just spin it clockwise until you find it) that lines up with a notch that sicks out from the block just above it. The camshaft marks are little arrows on the camshaft gears which line up with little marks on the cover plates that close the back of the gears in (about 1 o'clock)
Discard the valve all together and plug the vacuum line as if there was no bypass valve
On the front of the Throttle Body, its held in by 2 Star Screws.
Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft. Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft.
there are two kinds of timing marks. one is for ignition timing and one for valve timing.
The timing marks, on your 1.6 liter engine, can be found on the front of the main pulley. The timing marks will be scattered around the outside of the pulley.
The timing marks, on your Mitsubishi engine, can be found on the front main pulley. The timing marks will be on the outside edge of the pulley.
The timing marks can assist a mechanic in setting the engine timing. The number one timing marks will set the number one piston so that the number one valve can be properly adjusted.
The 1996 Geo Tracker 1.6 liter engine timing marks can be found on the outside of the main pulley. The timing marks will be scattered around the pulley.
No there is no timing marks on the power valve it will only go in one way the power valve opens win your bike hits high rpm get a repair manual it $its 20.00 it will help u alot.
If you are talking about ignition timing there are no marks. The timing is controlled by the computer according to various parmeters of sensors. If you are talking about valve timing the camshaft mark is on the head and the crankshaft mark is on the oil pump housing.
i have a mazda 1994 626 v6 24 valve car and i think the timing belt just broke where are all the timing marks crank shaft and cams?