The timing marks, on your 1.6 liter engine, can be found on the front of the main pulley. The timing marks will be scattered around the outside of the pulley.
When to change out a timing belt on 06 vectra sri Mileage wise
keep filling it till it reaches top lever mark on the dipstick and also make sure you are on level ground when topping up
aortic semilunar valve
You've realigned the marks, but did you check which piston stroke? The marks will align in two instances, top dead center on the compression stroke, and top dead center of the exhaust stroke. I'd bet money that you've aligned the timing marks to TDC exhaust stroke. That would explain 0 compression in all cylinders. Rotate your crank shaft by itself (leave the camshaft where it is) 360 degrees (one full turn) and you should then by aligned to TDC compression stroke, as it is supposed to be.
On the 1.8 DOHC GSi model the cam shaft timing sprockets have little marks along the edge of them. The two marks MUST be lined up closest to each other. The marks are very small and you may want to use your fingernail to find them. On the 1.6 SOHC model, the camshaft timing sprocket has the same type mark, but it must be at the 9 O'clock position. It should be EXACTLY on the top plan of the cylinderhead mating surface with the valve cover. On all Storm engines, the lower crankshaft timing sprocket has a small notch. That MUST be at the 12 O'clock position. It will line up with a small little triangle on the oil pump housing.
How long does it take to fit a concentic valve in a vauxhall astra
1.4 Eight valve engine. The water pump is the timing belt tensioner on this model. you need to slacken the pump and rotate it to tension the belt.
Hi! 2004 astra 1.4 16 valve enjoy model is an egr valve fitted to this model? (enjoy) thanks
PCV= Positive Crankcase Ventilation.It will be in the cylinder head cover.
This is an interference engine. The valves normall collide with the pistons when the belt breaks. Damage is usually bent valves, and sometimes broken valve guides also
dunno the marks seem strange to me have just pulled down my missus 1.8 n found when crank pulley mark is showing t.d.c. marks on cam sprockets are pointing at 3 oclock inlet and 9 oclock exhaust so will have to leave it till ive seen a photo sorry mate
If this engine is an interference engine it may have done damage to valve, piston, or head. Or the timing is off so far that the engine will not start. Install a new timing belt correctly and start the engine. You will then know if any damage was done.
I have a Astra F '97 1.4 litre DOHC 16 valve engine Average 6.5 to 8.5L/100km or 33 to 43 MPG (imperial)
Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft. Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft.
there are two kinds of timing marks. one is for ignition timing and one for valve timing.
The timing marks, on your Mitsubishi engine, can be found on the front main pulley. The timing marks will be on the outside edge of the pulley.
The timing marks can assist a mechanic in setting the engine timing. The number one timing marks will set the number one piston so that the number one valve can be properly adjusted.