answersLogoWhite

0


Best Answer

what are the wires for on the rear hatch door hydraulic pumps

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are the wires for on rear hatch struts on 1997 Chevy astro van?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why Chevy Astro does not start after rain?

Electrical... try plug wires


What does a tune up coast for a Chevy Astro?

I was quoted $120 without new spark plug wires.


Why doesn't 1995 Chevy Astro van start when it rains?

When was the last time the ign. wires were changed?


Why is a 94 Chevy Astro 4.3 still backfiring after changing the cap rotor plugs and coil?

Plug wires are installed incorrectly.


How do you replace the spark plugs and wires on a 2004 Chevy Astro van?

you can reach them by removing the tires and the wheel well guards [plastic]


How do you replace the spark plugs and wires on a 1994 Chevy Astro van?

you can get to some from the front and the ones in the back you can get to through the wheel wells


What might cause a 6-cyl 1986 Chevy Astro van to backfire?

It can be eithier plug wires crossed or burned valves. Have it checked out.


Where is crank sensor on 97 Chevy astro van 4.3?

The crank position sensor On your astro is located on front of the engine on timing cover, left side. Behind the crankshaft pulley. with a connector of 3 wires.


Where is the blower fan resistor in a 1997 Chevy astro van?

It is located behind the coolant and windshield washer reservoirs. The two wires on the blower motor will lead you to it.


How do you you fix a p0303 on a Chevrolet astro?

Try replacing the plugs and wires


Where is the thermostat located on a 1990 Chevy Astro?

It is located at the end of the top radiator hose (engine side) It is in a housing with 2 bolts probably has 1 bolt and 1 stud with wires attached to stud


How do you change spark plugs on a 1993 Chevrolet astro van?

Remove the spark plug wires from your 1993 Chevy Astro spark plugs. Remove the spark plugs with a 5/8 deep well socket, by turning the socket to the left. Reverse the process to install the new spark plugs.