0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace 2001 aurora rear bumper lights?
The rear fog lights are accessable from under the car. You have to reach up and under the rear bumper.
Can a rear parking light fixture be replaced without replacing the rear bumper?
yes it can!! go under your car to wear you see the wires to the light and undo the wires and take the light out then put and wire a new light fixture
Where is the spare tire in Grand Caravan 2010?
under rear bumper
How do you remove tail light assembly 2006 Scion TC to change tail light?
there is a dyi on the net, but bumper removal will be necessary, 2 bolts top of bumper in the rear cargo area 2 plastic bolts under rear section of bumper 2 plastic bolts under each corner of bumper 2 long screws by rear wheels going to top of bumper, then pull off
How do you remove the rear bumper of a 2004 Ford Expedition?
Behind / under the rear bumper there you will see 4 bolts on each side of the bumper. Have someone help you hold it while you remove the bolts. the installation is the reverse of removal.
What is impact bar on Chevy Cavalier?
its the rear reinforcement bar under the rear bumper. its also known as a rear impact bar
Where is the gas tank in a 1995 Jeep Cherokee?
It is in the rear, right under the rear bumper. There is probably a plastic cover surrounding it.
How do you remove the passat rear bumper?
how to remove 2013 passat rear bumper
How change the rear bumper on a Ford Mondeo?
The rear bumper is held in place with eight retaining bolts. Remove the retaining bolts and the rear bumper will come off. Reverse the process to install your new rear bumper.
How do you remove a vw passat 55 rear bumper?
Removing the Rear Bumper of a Passat...
How do you remove 2006 Toyota corolla rear bumper?
InstructionsLift the rear of the Corolla using a floor jack. Jack up on the rear jack point behind the trunk, and place a jack stand under each of the rear pinch welds. Then lower the vehicle onto the jack stands.Pry the plastic rivets off the inner wheel liner with a flat-head screwdriver.Remove the bolts that hold the bumper to the bumper bracket and support.Pull the bumper off the bumper support.Mount the new bumper. Align the mounting holes on the back of the bumper's mounting bracket with the bumper support, and thread and tighten the bumper. Replace the plastic rivets that hold the wheel liner to the rear bumper.Remove the jack stands, and lower the car.
Where are the trailer towing wires on a 2004 endeavor?
They are tucked up and behind the rear bumper assembly. They are there you just have to dig for them. Should be able to reach with your hands.
