0
Jorge German
Radinksy Baez
What else can I help you with?
What two statement describe characteristics of EIGRP?
Anthony henderson
Which two interface variables will determine the metric that is used on EIGRP?
The bandwidth and delay interface variables are used to determine the metric in EIGRP. These values are used in the calculation of the composite metric that EIGRP uses to determine the best path to a destination.
How you configure both eigrp and ospf to transfer a packet eigrp to ospf and ospf to eigrp?
we would need to redistribute ospf routes into eigrp and vice versa. redistribution will have to be done on an ASBR(autonomus system boundry router) eg: we have an ospf process wid process id 10 running and eigrp with ASN 20 running in our network redistribution on ASBR would be conf t router ospf 10 redistribute eigrp 20 subnets metric 1 and in eigrp conf t router eigrp 20 redistribute ospf metric 1 1 1 1 1 we see i used 5 ones in eigrp process to redistribute opsf into eigrp. thes 1's are metrics for eigrp namely load bandwidth delay reliability
What is the administrative distance of eigrp-learned routes that have been injected into eigrp via redistribution?
170
A router has learned two equal cost paths to a remote network via the eigrp and rip protocol are using their default configurationswhich path to the remote network will be install the routing table?
the path learned via EIGRP
Why is the show ip route command important for troubleshooting commands?
Compared to RIP, EIGRP has a lower administrative distance. Compared to EIGRP, RIP has a higher metric value for the route. Compared to RIP, the EIGRP route has fewer hops. Compared to RIP, EIGRP has a faster update timer.
Which cisco IOS command would display the current status of EIGRP neighbors?
show ip eigrp neighborsw
Which default eigrp configurations must be modified to allow an eigrp router to advertise subnet that are configured with vlsm?
autosummarization
Which default EIGRP configuration must be modified to allow an eigrp router to advertise subnets that are configured with vlsm?
autosummarization
Which default EIGRP configuration must be modified to allow a router to advertise sub-nets that are configured with vlsm?
Which default EIGRP configuration must be modified to allow an EIGRP router to advertise subnets that are configured with VLSM
What is EIGRP for cisco protocols?
Enhanced Interior Gateway Routing Protocol (EIGRP) was once as Cisco Propitiatory routing protocol for Cisco routers. However many routers that are not Cisco now support the use of EIGRP.
How do you setup eigrp protocol?
router#config t router(config)#router eigrp 100 #net NETWORK ADDRESS
