answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What are two ways of turning off DTP on a trunk link between switches?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the communication link between two switches in a telephone network known as?

A trunk


What is the difference between a access port and a trunk port?

• Access link: An access link is a link that is part of only one VLAN, and normally access links are for end devices. Any device attached to an access link is unaware of a VLAN membership. An access-link connection can understand only standard Ethernet frames. Switches remove any VLAN information from the frame before it is sent to an access-link device.• Trunk link: A Trunk link can carry multiple VLAN traffic and normally a trunk link is used to connect switches to other switches or to routers. To identify the VLAN that a frame belongs to, Cisco switches support different identification techniques (VLAN Frame tagging). Our focus for CCNA examination is on Inter-Switch Link (ISL) and 802.1Q.A trunk link is not assigned to a specific VLAN. Many VLAN traffic can be transported between switches using a single physical trunk link.


If two switches each support all types of trunk encapsulation on a link between them which type of encapsulation will be negotiated?

12


Which combination of DTP modes set on adjacent switches will cause the link to become an access link instead of a trunk link?

dynamic auto - dynamic auto


What is a VLAN trunk?

A VLAN trunk allows for data to travel across a single link between two devices even if the data is from multiple VLANs. This allows for reduced cabling needed as for you won't have to run multiple cables between switches in order to have up-links for every VLAN.


What is a router on stick inter vlan routing?

A physical router device with an interface that routes between two or more VLANs that are attached to a VLAN network segment by a trunk link. In other words a " router on a [ TRUNK ] " which is originating from switches with independent non routing VLANs.


What is Difference between access link and trunk link?

Access like carry the single vlan information & Trunk link able to carry the multiple vlan information when frames are travels from trunk mani shanker


Which IEEE trunking protocol is used to encapsulate data traffic over a trunk link on a Cisco switch?

there are 2 available protocols used to encapsulate data traffic over a trunk link on a cisco switch 1. 802.1q is proprietary works only between 2 cisco switches 2. ISL is open standard works with any switch..


What is the difference between D-link switch and a normal cisco switches?

Technology wise there is no such difference.


How would a physical connection between 2 switches via a hub be characterized by RSTP?

Link-type shared


What are the pluses and minus to a KVM switch?

In order to find more information about a KVM switch; I found this link very helpful. It is all about KVM switches. The pluses, the minus' and everything in between. www.kvm-switches-online.com/


When you configure 802.1Q trunks on catalysts switches which limitation is imposed?

you must ensure a loop free topology before disabling the spanning-tree protocol you must configure the same native VLAN on both ends of the trunk link