A simple manual wire stripper is a pair of opposing blades much like scissors or wire cutters. The addition of a center notch makes it easier to cut the insulation without cutting the wire. This type of wire stripper is used by rotating it around the insulation while applying pressure in order to make a cut around the insulation. Since the insulation is not bonded to the wire, it then pulls easily off the end. This is the most versatile type of wire stripper.
Another type of manual wire stripper is very similar to the simple design previously mentioned, except this type has several notches of varying size. This allows the user to match the notch size to the wire size, thereby eliminating the need for twisting. Once the device is clamped on, the remainder of the wire can simply be pulled out, leaving the insulation behind.
Wire strippers are used to remove (strip) the insulation from the end of a wire.
The most highly recommended type of binding wire used to bind steel is stainless steel binding wire. Annealed steel wires and galvanized steel wire can be used as well.
question is incomplete!
Easy. A rod or electrode used in welding stainless steel. Or to "clad" a surface with stainless steel. (Nothing more than laying down a layer or layers of stainless.) MIG wire also comes in stainless steel. Their are different types of stainless steel and rods/wire/electrodes to use on them.
m=F/g where
the hot and neutral are wired forwards the ground and neutral are wired backwards
Wire strippers come in a large variety of shapes, designs and sizes. There is no standard size. Wire strippers often come in a set with wire cutters and can be bought at home renovation stores.
Electrical wire is the type of wire that is used in electrical equipment. To strip the wires, you need to use wire strippers. There is also special tape called electrical tape that is used to secure the wire.
If you tried to cut a wire that is too hard, it will damage the cutters.
To create a thermocouple one needs thermocouple wire, a means of spot welding the wire, and wire strippers. A thermocouple is used to measure temperature.
They used to be dancers, but not strippers.
They used to be dancers, but not strippers.
No, most cutters and strippers can do the job of a Klein with the same aptness.
You would use a set of wire strippers made for stranded wire and proper size. If the strippers are made for stranded and solid make sure you use the size identifications for stranded not solid!
You can buy wire strippers from several sites. One example of these sites is Amazon. If you want a cheaper one, you can also buy it from Chinese resellers like DealExtreme and LightInTheBox.
Theyre like pliers, just with a sharp edge and they can be slid along the coating of a wire to strip it
To strip wires surrounded by an insulator, like rubber for instance. That way you can splice them etc.
If you insist on removing the rubber coating on a wire chemically, try using acetone. Otherwise, throw it in a fire or use old fashioned wire strippers.