There are four ways to find a ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
replace rear axle bearing
1.5 qts of 80w90 oil 1.5 qtys of 80w90 weight oil
There are four ways to find a ratio. 1 A dealer can normally tell from the vin number. 2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement info. 3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires. 4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
I cant be totally sure but I think it is the Diff lock engaged warning light Best wishes
That depends on the rear axle ratio. 2500 rpm ?That depends on the rear axle ratio. 2500 rpm ?
Show video on
Open the drivers door and look at the informaion sticker(s) for the axle code Each axle code corresponds to a specific axle ratio
a srrewed up axle, tranny, or somethnig is binding.
These were the options in 2000: [DMC]=Axle Ratio - 3.21 [DMD]=Axle Ratio 3.55 [DMF]=Axle Ratio 4.10 [DMH]=Axle Ratio 3.92 These were the options in 2000: [DMC]=Axle Ratio - 3.21 [DMD]=Axle Ratio 3.55 [DMF]=Axle Ratio 4.10 [DMH]=Axle Ratio 3.92
I ASSUME axle code " 86 " is the same as it is on the ( 1996 ) Ford Ranger ( 3.73 gear ratio , conventional / non - limited slip )
As an Isuzu mechanic, I would not recommend an individual trying this. There is a large plate holding it in place, along with two snap rings behind it holding the bearing and seal in place.
hoew do you remove a c v axle from a 97 isuzu rodeo front right