Have you replaced the battery in the fob?
I have a jeep 1994 Jeep Grand Cherokee and found this answer on this site under programing a 1995 jeep Grand Cherokee. Its a very good description uses the same FOB.
I just saw a post that said to take out the little key, insert a small flathead screw driver into the fob, and it should pop apart to allow battery replacement.
Have to take it to the dealer.
it has to be done by the dealer. =(
With the dealers scan tool.
Dealer only on 96+ newer Jeep Grand Cherokee's
Find the little slot on the side of the fob near the PANIC button. Insert a small flat blade screwdriver or a paper clip into the slot and twist to separate the 2 halves of the fob. Replace the 2 CR 2016 3 volt batteries and snap the fob back together.
the key fob battery is the battey in a key fob torch
A small battery that fits in a key fob or remote.
If you have the key fob on your person, that is a lock or unlock button.If you have the key fob on your person, that is a lock or unlock button.
Time for a new battery in the fob.
Remove the valet key from the fob and behind it is a small Phillips screw. After that the fob will split and the battery is visible.
It's not that the key fob stopped working, but, if your car battery is dead, it's the car that has no power to pop the door locks.
If you know for sure that the alarm is functioning correctly, but the key-fob doesn't operate - either the fob is faulty or the battery is flat. Replace the battery - if the fob operates the alarm, then the battery was flat. If the alarm still doesn't operate, then the fob is faulty. You can always test the battery with a multimeter - although you may have to dismantle the remote to get at the battery !
Open the key fob and remove the battery which has a # on it, and then buy a duplicate.
what is the replacement battery for a 2003 Honda accord key fob
Changing the battery in the key fob to a Pontiac Solstice is pretty simple. Just remove the back of the key fob, and take out the old battery. It takes a hearing aid battery, and they can be found at any chain pharmacy. Put in the new battery and replace the back to the key fob. It is now ready to go!
You do not have to reset the key fob when changing the battery.
No, You do not need a key fob to start a car. When starting a car, you put the key in the ignition and turn. Power comes from car battery, not from the key fob battery!
Changing a Mazda 2 battery in the key fob is quite simple. You will need to use a flat head screwdriver to pry open the fob. You will then take the battery out with the screwdriver and replace it.
The battery in the key fob of a Volvo v70 is changed by opening the case with a penny or nickel. The battery can then be taken out and a new battery slid into position.
The fob has a pry slot and prys apart.
nothing works and I replaced the battery. to the fob
Open the FOB and find out.