You did not supply enough information. See sources and related links below to lookup brake light lamp part numbers by vehicle make, model and year.
there is a fusebox in the trunk (on lefthand wall).
1997 Cadillac Seville center high mount stop (third 3rd brake light) bulb replacement: Purchase the correct replacement center high mount stop (third 3rd brake light) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the center high mount stop (third 3rd brake light) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
To replace the third brake light on a 2001 Cadillac Seville SLS, you will first need to access the light by removing the trim panel on the rear deck lid. This may involve removing screws or clips holding the panel in place. Once the panel is removed, you can then access the back of the third brake light assembly, disconnect the wiring harness, and remove any mounting screws to take out the old light. Finally, install the new third brake light, reconnect the wiring harness, secure it with mounting screws, and reattach the trim panel.
16.7 feet or 200.9inchs
My Haynes manual says this is how it's done. Open the trunk On early models, detach the trim panel and remove the nuts holding the light housing in place, then withdraw the housing from the vehicle On later models, the light housing runs the full width of the vehicle. Remove the nuts securing the taillight panel to the body. Pull the taillight panel out. On all models, rotate the bulb holder(s) 1/8-turn counterclockwise and pull it out of the housing, then pull the bulb out.
275
the manual release lever is attached to the parking brake pedal assy
under and to the right of the distributor
2000 Cadillac Seville SLS 4.6L SFI DOHC 8cylThe Spark Plug Gap.050 (In thousandths of an inch)
how do you check a/c codes on a 2000 Cadillac Seville sls
A flexplate is used in automatic transmissions while a flywheel is used in manual transmissions. The 2000 GMC Jimmy SLS appears to have a manual transmission, so it uses a flywheel.
The brake line size for a 2002 GMC Sonoma SLS typically uses 3/16-inch diameter brake lines. However, it's always good practice to verify with a repair manual or parts supplier for specific applications, as there can be variations based on different configurations or modifications.