AnswerWhy not get the whole assembly at a salvage yard?
Find and remove the daytime driving lite relay and or fuse, or loosen ebrake adjust a little and drive with ebrake on one click or jumper across the switch at ebrake that makes lights think its on but ya didnt here that from me LOL, Have you tried to push the small button located just to the left and below the headlight switch? Press that button four times in a row. You will hear a chime and your auto headlights will be disabled. (This may only temporarily disable them. I think after you shutoff and then restart, the auto headlights are enabled again.)
In some cases you can disconnect the plug on the ebrake switch. I was able to access it by pulling back on the ebrake side cover.
Put it in gear
what knds of car do yoy have .
with your ebrake cable.
the wire needs ground to function. Connecting it to the ebrake allows it to ground so just connect the video wire to any ground and it will function as if it was connected to the ebrake
usually this is done at the ebrake itself. there are two wires going to it.
press your ebrake one or two clicks and leave it on
put in reverse and go about 5 then slam it into drive and gas it to the floor or u can use the ebrake and go half way so you dont burn out the transmission and make sure that your ebrake is fully tightened other wise it wont work
Right next to the ebrake there is a pop off plastic door. There are your fuses.
Left side, under dash, by the ebrake/hood latch lever assembly..