0
What else can I help you with?
How do you replace the speedometer cable on a 1991 Toyota Corlla standard?
If it has a mechanical speedo,take the negative battery cable loose first then take the spedo housing loose from the speedo first then pull the cable out of the housing. Then take the housing loose at the bottom and remove the part of the cable that is twisted off. Get a new cable and install it with lots of cable lubricant. Then hook up the botton end then the top end of the housing. Hook up the neg battery cable
How do you replace a speedometer cable on an '85 Chevy Blazer?
Hey Criss==First take it loose at the speedometer end then pull it out of the housing. If it is broken, take it loose at the trans and remove the broken part. Put them together and measure the length. Go to the store and get a cable the correct length and get some speedo cable lube. In stall the cable into the housing with lots of grease and hook up the ends and that is all. If the housing is bad you will need a new housing and cable. GoodluckJoe
How do you replace the starter on a '92 Grand Am?
First make sure it is the starter that is at fault. Then take the neg battery cable loose at the batery. Then take off the wiring then the bolts holding it on and work it out.
Why does your motorcycle take off while holding the clutch?
You may have a loose clutch cable.
How do you tighten a loose battery cable?
Use the appropriate socket on the nut and tighten it. Make sure the cable is in the correct position first.
Dash gauges dont work?
Probably a fuse or a loose cable. Try that first.
How do you change the shifter cable in a 1995 Buick Century?
Take the console out then unhook the cable from the shifter. RAise the car and take it loose from underneath. Use stands when you are under the car.
How can I troubleshoot a loose cable connection in my computer system?
To troubleshoot a loose cable connection in your computer system, first power off the computer and unplug it. Then, check the cable connections to ensure they are securely plugged in. If a cable is loose, gently push it back into place. Test the connection by powering on the computer and checking if the issue is resolved. If the problem persists, try using a different cable or port to see if that resolves the issue.
How do you install an alternator in a 1971 Plymouth duster with a slant six?
first unhook the battery cables and then take the alternator belt loose and then take the 3 bolts out that hold the alternator on and take the wiring harness out of the alternator and the red battery cable off and it's out.
Loose Clutch Cable?
get it tightened
How do you replace the starter in a 1995 Olds 3.1 liter engine?
First remove the negative battery cable. Then take the wires off of the starter solonoid. Then take the bolts out of the starter and remove it. Sometimes you have to take the exhaust loose to get it out. If necessary, get a manual from aparts store. It will show you how.
What is the term used to describe a network cable lyong loose in a network cable lying loose in a high-traffic area?
trip hazardWhat_is_a_network_cable_used_for
